RadioLink AT9S PRO - Part 6. MULTIROTOR FUNCTIONS; 6.1 MULTIROTOR BASIC MENU; 6.1.1 MODEL TYPE

Radiolink Electronic Ltd
www.radiolink.com
74
5.3.11 SWASH-RING
This function is to limit movement of swash plate to avoid damage to the SWASH ROB during operation
aileron and ELEVATOR. It is affected in 3D flight. Movement of AILERON and ELEV is limited in the circle.
Adjustability:
• Initial: 100%
• adjusting range:
0-200%
5.3.12 THROTTLE NEEDLE (see ACRO MENU 3.3.15)
5.3.13 PROG MIX (see ACRO MENU 3.3.1)
Goals
Steps
Inputs
Correct the
tendency of the
model to change
altitude.
Open
THRO- MIX
function.
to BASIC menu, again to ADVANCE
to THRO-MIX
Activate the function.
to MIX ， to ON
Adjust the rate.
Ex:
IDL1
(AIL to TH) 10%
to IDL1 (AIL→TH) ， to 10%,
Repeat as needed.
Close
Goals
Steps
Inputs
To prevent damaging the swash
linkage by simultaneous operation
of the ailerons and elevators, set
the limit point where swash throw
stops.
＊Adjust the rate at the maximum
swash tilt by simultaneous
operation of the ailerons and
elevators.
Open SWASH-RING
function.
to BASIC menu, again to
ADVANCE
to SWASH-RING
Activate the function.
to MIX ， to ACT
Adjust the rate Ex:
90%
to RATE ， to 90%，
Close