RadioLink AT9S PRO - Multirotor Basic Menu; Model Type; Aux Channel Setting

Radiolink Electronic Ltd
www.radiolink.com
77
Set the rate in each
attitude. Ex: ATTI is 50%.
to ATTI ， to 50%
Change CH6, use VR (D)
to control change other
channels as needed.
to CH6 ， to VR(D).
Repeat as needed.
Close
6.1 MULTIROTOR BASIC MENU
The basic function menu is same like ACRO, GLID and HELI, please find the detail in the former chapters.
Below is the special option:
6.1.1 MODEL TYPE
Different from ACRO, GLID AND HELI, MODEL TYPE for
MULTIROTOR has an additional function TRIM, which is
controlled by the VR switch. Set the TRIM OFF to avoid a
mis-operation damage to the model.
6.1.2 AUX Channel setting
AUX channel for MULTIROTOR is channel 6 to 10, same like ACRO, GLID and HELI, to set auxiliary channel.
CH5 is special for ATTITUDE, enter CH5 and press PUSH for ATTITUDE. Select 3-section and 2-section
switch to get 6 different attitudes. By DIAL set 6 different rates according to the attitudes.
6.2 ADVANCE MENU FOR MULTIROTOR
Goals
Steps
Inputs
Select proper MODEL
TYPE. (Ex:
MULTIROTOR）
Open BASIC menu, find
MODEL TYPE.
Turn on the transmitter, for 1 sec. to BASIC
menu (If ADVANCE, again)
to MODEL TYPE
Go to MODEL TYPE
to TYPE
Choose proper model
type (Ex: MULTIROTOR).
Confirm the change.
to MULTIROTOR, for 1 sec. ‘Are you sure?’
Displays, to confirm.
Turn on the trim.
to AILE-TR ， to ON.
Repeat above to turn on other trims
Close