RadioLink AT9S PRO - 6.2 ADVANCE MENU FOR MULTIROTOR; 6.2.1 ATTITUDE; 6.2.2 THROTTLE CURVE (see ACRO 3.3.14); 6.2.3 PROG. MIX (see ACRO 3.3.1)

Radiolink Electronic Ltd
www.radiolink.com
76
TYPE.
(Ex: MULTIROTOR)
find the MODEL TYPE.
menu (If ADVANCE, again)
to MODEL TYPE
Go to TYPE
to TYPE
Choose proper model
type (Ex: MULTIROTOR).
Confirm the change.
to MULTIROTOR, for 1 sec. ‘Are you sure?’
Displays, to confirm.
Name the model.
Note that you do not need
to do anything to ‘save’ or
store this data.
In BASIC menu, Open
MODEL SEL.
to MODEL SEL. ， to NAME (the 1
st
character of model name is highlighted)
Input MULTIROTOR’s
name.
Close
to change the 1
st
character. . move to
next character, repeat as needed. to BASIC.
For proper control
operation, reverse servos
as needed.
In the BASIC menu, open
REVERSE.
to REVERSE ， to choose REV.
Choose desired servo
and reverse its direction
of travel.(Ex: reverse
rudder servo)
to CH4：RUDD, ，so REV highlighted, ‘Are you
sure?’ Displays.
Repeat as needed. to BASIC.
Adjust travels as needed to
match model’s recommend
throws(usually listed as high
rates)
From BASIC menu
choose END POINT.
to END POINT,
Adjust the servo’s end
points.(Ex: throttle servo)
Close
to CH1:AILE ， VR(A), to desired
percentage. VR(A) to repeat above steps.
Back to choose D/R EXP.
to D/R,EXP
Set up dual/triple rates and
exponential (D/P, EXP)
(Note that in the middle of
the left side of the screen is
the name of the channel
and the switch position you
are adjusting. Two or even
THREE rates may be set
per channel by simply
choosing the desired switch
and programming
percentages with the switch
in each of its 2 or 3
positions.
Choose the desired
control and set the first
(Ex: high) rate throws and
exponential.
to CH ， to CH:2 (ELEV)
SwA screen reads ELEV (UP)
to D/R
Elevator Stick to set rate.
Elevator Stick to set rate. （Normally set
the same as down.
to EXP
Elevator Stick to set rate.
Elevator Stick to set rate.
set the first (Ex: low) rate
throws and exponential.
to D/R SwA to down，repeat to set low rate.
Optional: change dual
rate switch assignment.
to SW ， SwG， SwG to center
position. Repeat steps above to set 3
rd
rate.
Adjust AUX-CH and Knob.
On BASIC menu, then
open AUX-CH function.
to AUX-CH,
Choose CH5 to set
ATTITUDE
to CH5, to ATTITUDE
Assign the switch to
control attitude. Ex: SW3
is SWC，SW2 is SWB
to SW3, ， to SWC，
to SW2, ， to SWB，