RadioLink AT9S PRO - PART 4 GLIDER MODEL FUNCTIONS; 4.1 SET BASIC MENU OF GLID; 4.3 GLID ADVANCE MENU

Radiolink Electronic Ltd
www.radiolink.com
48
auxiliary channel such as 8, and then using some creative mixes.
Goals
Steps
Inputs
Activate
THR-DELAY for a
ducted-fan replica
of a
turbine-powered
MULTIROTOR.
Slow the servo
response by one
second.
Open THR-DELAY
to BASIC . again to ADVANCE
to THR-DELAY,
Activate the function.
to MIX.PUSH. to ACT.
Adjust the RATE to match the
desired servo speed.(Ex:40%)
to RATE.PUSH to 40%
Close
3.3.14 THR CURVE (ACRO)
This function adjusts the throttle operation curve for optimum the engine
speed to throttle stick movement.
Note: If the throttle EXP function is activated, you can not use
THR-CURVE function simultaneously.
Adjustability:
• Separate curves for each switch position are available.
• Moving and deleting the curve point: The curve point (-STK-) can be
moved to the left or right by turning the DIAL (up to 2% in front of the adjoining point) and deleted/returned by
pressing the DIAL for one second alternately.
Goals
Steps
Inputs
Base point: Adjust base point of
throttle curve until engine idles
reliably.
-Out-:output,servo position.
-STK-: curve point, stick position.
Open THR-CURVE
to BASIC . again to ADVANCE
to THE-CURVE,
Activate the function.
to MIX.PUSH to ON.
Adjust the 1
st
point
to P1(-out-).PUSH to desired servo
position
Optional: assign the switch.
to SW.PUSH， to desired switch.
Optional: Move the curve
point.(Ex: point 3)
to P 3 (-stk-),PUSH to desired
curve point to move to left or right.
Optional: delete the curve
point. And return the curve
point.(Ex: point 3)
to P 3 (-stk-). for 1sec.to delete the
curve point.
to P 3 (-stk-)， for 1sec.to return
Adjust the next point.
Repeat as needed.
Close