GOVERNOR (HELI): ch. 7, or ch. 7 and 8
THR-NEEDLE (ACROHELI): ch. 8
Remember that if you assign primary control of a channel to a
switch which you later use for other functions (like dual/triple rates
or airbrakes), every time you use that other function you will also be
moving the auxiliary channel.
2.3.12 TIMER submenu (stopwatch functions):
Controls three electronic clocks used to keep track of time remaining
in a
com
petiti
on
time
allo
wed,
flyin
g time on a tank of fuel, amount of time on a battery, etc.
Adjustability:
• Count down timer: starts from the chosen time, displays time remaining. If the time is exceeded, it
continues to count below 0.
• Count up timer: starts at 0 and displays the elapsed time up to 99 minutes 59 seconds.
• Count down timer (Stop type): starts from the chosen time, displays time remaining, and stops at 0.
• Model timer: cumulates ON time up to 99 hours 59 minutes each model. Once Model timer function is
turned off, the cumulate time will also be reset to "0:00".
• Independent to each model, and automatically updates with model change.
• In either TIMER mode, during the last twenty seconds, there's a beep each second. During the last ten
seconds, there's two beeps each second. A long tone is emitted when the time selected is reached.
(UP/DOWN TIMER)
• To Reset, choose the desired timer with the CURSOR lever (while at the startup screen), then press and
hold DIAL for 1 second.
• Activation by either direction of SWITCH A-H, by THROTTLE STICK (STK-THR) (Using the THROTTLE
STICK is convenient if you are keeping track of fuel remaining, or for an electric, how much battery is left), by
LOGIC SWITCH Lsw1-Lsw3 or by the power SWITCH (PWR SW).
To Next Page
Loading...
