RadioLink AT9S PRO - 2.3.11 Auxiliary Channel Function

Radiolink Electronic Ltd
www.radiolink.com
26
Goals
Steps
Inputs
Change the receiver
Failsafe command for
channel 8(gasoline engine
kill switch) to a preset
position. NOTE: This is
one of several functions
for which the radio
requires confirmation to
make a change.
Open BASIC menu, then
Open F/S.
for 1s .(If ADVANCE again) .
to F/S, PUSH
Ch oo s e c ha nn e l t o
ch an g e( Ex : C H. 8)
to CH8 ,PUSH
Set and confirm fail safe
command.
that controls CH8 to desired OFF
position.
to adjust ,PUSH
Repeat as desired
Close
2.3.11 Auxiliary Channel Function
•Auxiliary channel: The auxiliary channel switch is used to do some auxiliary functions, such as opening or
closing the throwing chamber, opening or closing the control machine that releases smoke, etc. Each
auxiliary channel can be customized with any switch, slider or knob to control (The slider knob is usually used
in the pan/tilt camera), or multiple channels can be set on the same switch, slider or knob, and the setting
effect can be viewed on the'rudder amount display' interface of the remote control.
Vehicle and ship models generally have 2 basic channels, and airplane models generally have 4 basic
channels. All channels except for the basic channels of the remote control are auxiliary channels.
AT10II can not only customize the auxiliary channels, but also customize the 4 basic channels to meet the
personalized needs of model friends to a greater extent. The specific setting methods are as follows:
Long press the Mode button for 1 second to enter the basic menu, turn the PUSH button to select'System
Settings', tap the Push button for 1 second to enter the'System Settings' menu, then select the'Joystick Mode'
to "—", tap End once Key to return to the basic menu interface, and then use the PISH key to select "auxiliary
channel" to see the following interface.
【AUX-CH】
CH1：STK1
CH2：STK2
CH3：STK3
CH4：STK4
CH11：SwD
CH12：VrE
CH5：SwF
CH6：----
CH7：SwC
CH8：VrB
CH9：SwB
CH10：SwA
Related channels:
GYRO SENSE (ACRO): CH. 5, 7, or 8
GYRO SENSE (HELI): CH. 5
GOVERNOR (HELI): CH. 7, or CH. 7 and 8
THR-NEEDLE (ACRO􀀒HELI): CH. 8
Remember that if you assign primary control of a channel to a switch which you later use for
other functions (like dual/triple rates or airbrakes), every time you use that other function you will
also be moving the auxiliary channel.
Goals
Steps
Inputs
Assign flaps to the right
slider[VR(E)] and set
channel 7 to NULL in
preparation to use it as
a smoke system control
(the smoke system
being activated later by
a throttle to CH7 MIX).
Open BASIC menu, then to
AUX-CH
for 1s .(If ADVANCE again) .
to AUX-CH,PUSH
Choose channel to change
(Ex:CH6)
to CH6，PUSH， to desired switch,
PUSH
Repeat above steps as desired.
(Ex:CH7=NULL)
to CH7,PUSH, to NUL