RadioLink AT9S PRO - 3.3.4 FLAP-TRIM

Radiolink Electronic Ltd
www.radiolink.com
36
• Rate: the percentage of the slave’s range it will move upon maximum input from the master channel. Ex:
RUDDERAILERON mix, 50%. Ail range=1''. When rudder is moved full right, ailerons move 1/2''.
MASTER
SLAVE
LINK
TRIM
SWITCH
POSITION
RATE
OFFSET
RUDD
AILE
OFF
OFF
ANY
NULL
50%
0
• Offset: Offsets the slave’s center is relative to the master. Ex: Smoke valve opens wider per throttle servo
position when smoke SWITCH is ON. Smoke servo’s neutral is moved down from THROTTLE STICK center
to the bottom.
MASTER
SLAVE
LINK
TRIM
SWITCH
POSITION
RATE
OFFSET
OFST
AUX2
OFF
ON
STK-THR
Stick at 1/2.for 1 sec.
100%
0
MASTER
SLAVE
LINK
TRIM
SWITCH
POSITION
RATE
OFFSET
THRO
AUX2
OFF
OFF
E
DOWN
100%
100
%
Goals
Steps
Inputs
Set up a FLAP-ELEV
mix:
ON when SWITCH C is
in the down position.
No elevator movement
when flaps move
up(spoilers),5%elevator
movement when flaps
move down. Link should
be ON if mode has twin
elevator servos.
Otherwise, Link remains
OFF.
Open an unused programmable
mix.(Ex: use PROG.MIX3 since it
is already set up for
FLAP-ELEVATOR)
to BASIC menu, again to ADVANCE
to PROG.MIX PUSH
Activate the function
to MIX，PUSH， to ON, PUSH
Choose master and slave
channels.
Already CH6 .Already CH2
Optional: set Master as OFST or
VR(A-E)
to Master，PUSH，
to desired choice
Set LINK and TRIM as needed.
to LINK,PUSH , to DWON
Assign SWITCH and position.
(Ex: change from E to C，Down)
to SW，PUSH, to SwC
to POSI，PUSH to DOWN
Optional: set switch to STK-THR to
activate mix with THROTTLE
STICK.
to SW ,PUSH to STK-THR
to POSI， Throttle Stick to desired
point .
Push 1sec.to set.
Optional: set switch position to
NULL. Make mix active at all time.
Not complete with STK-THR.
to POSI, PUSH, to NULL
Set rate. (Ex: Lo=0%,Hi=5%)
to RATE ,PUSH VR(A)， leave at
0%， VR(A)past center . to 5%
Set OFF SET, if needed.（Ex：0）
to OFST to 0%
Close