RadioLink T8S(BT) - Page 31

RadioLink Electronic Limited
www.radiolink.com
30
After computers are connected to T8S via a USB data cable, there may appear many selectable COM
ports. The COM port can be found according to the following methods:
1) Press “win+R” on the keyboard;
2) Type “devmgmt.msc”, and type “ENTER”;
3) In device manager, click on “COM AND LPT”, then you can find the correct COM port.
After computers are connected to T8S via a USB data cable, there may appear many selectable COM ports.
Note: If you had found COM port in the device manager, but the corresponding COM port is not
displayed on firmware upgrade software. Then you can try to close this firmware upgrade software and
reopen it.