EasyManuals Logo

Radiometer Analytical TitraLab TIM960 User Manual

Radiometer Analytical TitraLab TIM960
68 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
Introduction 9
When Cloudy/Stormy/Question mark icons appear, press 1 to run
the “Check” command.
Depending on the icons displayed, the Titration Manager will
automatically guide you through the steps necessary to run the
analysis
.
a. Connect/install the electrode(s)
Connect/install electrodes and temperature sensors, Refer to
Short Form Reminder no. 1.
b. Install reagents(s)
If the burette is not installed, the Titration Manager will
automatically guide you to the Install burette procedure.
Refer to Short Form Reminder no. 2 and "Reagent
management using RFID tags" at the end of this chapter.
c. Calibrate electrode(s)
Refer to chapter 4 and Short Form Reminder no. 4.
d. Calibrate reagent(s) or Enter titre
Run the reagent calibration (refer to chapter 4 and Short Form
Reminder no. 5) or enter the titre manually.
e. Run the method or the sequence, when Sunny icons are
displayed,
Refer to Short Form Reminder no. 6 and 7.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Radiometer Analytical TitraLab TIM960 and is the answer not in the manual?

Radiometer Analytical TitraLab TIM960 Specifications

General IconGeneral
BrandRadiometer Analytical
ModelTitraLab TIM960
CategoryLaboratory Equipment
LanguageEnglish

Related product manuals