RADWAG AS series Operating Instruction

47
− If option FrEE was chosen, you must enter quantity of sample, which will
serve to determine mass of single detail
− Pressing F key chooses digit which will be changed
− Pressing UNITS changes value of digit
• Confirm entered value by pressing PRINT key
• Display will indicate LoAd message – place on the pan as many details as
entered during option
• Press PRINT key – balance will indicate quantity of sample (PCS symbol
is active)
• add remaining details, display will indicate their quantity.
Return to weighing
(see - 7.1.2. – return to weighing).

RADWAG AS series Specifications

General

Display	LCD with backlight
Maximum Capacity	Varies by model
Readability	Varies by model
Pan Size	Varies by model
Calibration	Internal or external, depending on model
Stabilization Time	≤ 3 seconds
Interface	RS232, USB
Repeatability (Standard deviation)	Varies by model
Linearity	Varies by model
Net Weight	Varies by model
Protection Class	IP 43