RADWAG AS series User Manual

- 88 -
Function SWITCH OFF CONTINUOUS TRANSMISSION IN BASIC MEASURING
UNIT
Command C0 CR LF
Function SWITCH ON CONTINUOUS TRANSMISSION IN BASIC MEASURING
UNIT
Command C1 CR LF
Function SWITCH OFF CONTINUOUS TRANSMISSION IN CURRENT
MEASURING UNIT
Command CU0 CR LF
Function SWITCH ON CONTINUOUS TRANSMISSION IN CURRENT MEASURING
UNIT
Command CU1 CR LF
Function GIVE FACTORY NUMBER
Command NB CR LF
Function GIVE MEASURING RANGE
Command FS CR LF
Function GIVE SOFTWARE REVISION
Command RV CR LF
Function GIVE OR CHANGE DATE IN A BALANCE
Command PD CR LF (causes sending data on set date or changes the date)
Function GIVE OR CHANGE TIME IN A BALANCE
Command PD CR LF (causes sending data on set time or changes the time)
Function GIVE ENABLED WORKING MODE
Command PM CR LF
Function SEND SETUP
Command PS CR LF (causes sending complete data on balance setup – printout of
parameters)
Function “BEEP” SOUND
Command B CR LF (causes immediate activating of beep sound in a balance)
Function GIVE LAST CODE ERROR
Command ER CR LF (causes sending code of last saved error in a balance)
Function SEND TEXT STRING
Command DS CR LF (causes previewing a sequence of characters)
Function ERASE TEXT STRING
Command CS CR LF (causes erasing a text string and restoring default display status)

RADWAG AS series Specifications

General

Display	LCD with backlight
Maximum Capacity	Varies by model
Readability	Varies by model
Pan Size	Varies by model
Calibration	Internal or external, depending on model
Stabilization Time	≤ 3 seconds
Interface	RS232, USB
Repeatability (Standard deviation)	Varies by model
Linearity	Varies by model
Net Weight	Varies by model
Protection Class	IP 43