RADWAG AS series User Manual

- 80 -
a balance: slot DB 9/F – a computer slot DB 9/F (with control of data transmission)
Balance Computer
2 (RxD) 3 (TxD)
3 (TxD) 2 (RxD)
4 (DTR) 6 DSR
5 (GND) 5 (GND)
6 (DSR) 6 (DTR)
7 (RTS) 8 (CTS)
8 (CTS) 7 (RTS)
19. COOPERATION WITH A CITIZEN LABEL PRINTER
Ensuring correct balance cooperation with a label printer requires acting as specified in the
following description. Use computer software “ETISOFT LABELS” to design a label
template according to user needs:
− Design size of a label
− Design number and type of data to be included in a label
CAUTION:
In order to correctly print variables from a balance on a label printer, the variables should
have a required space (number of characters) designed on a label. Number of characters
needed for each variable is specified in a below tables: 2, 3 and table 4.
Save a label template on a computer disc and name it using alphanumeric characters.
Assign designed label template to memory of a printer CITIZEN CLP-521:
− Set baud rate for RS 232 interface of a label printer to 9600b/s
− An instance of a designed label template named “Label01”
−
Fig. 66. A label template

RADWAG AS series Specifications

General

Display	LCD with backlight
Maximum Capacity	Varies by model
Readability	Varies by model
Pan Size	Varies by model
Calibration	Internal or external, depending on model
Stabilization Time	≤ 3 seconds
Interface	RS232, USB
Repeatability (Standard deviation)	Varies by model
Linearity	Varies by model
Net Weight	Varies by model
Protection Class	IP 43