Press to select digit that is to be edited.
Press to set digit value, 0 - 9.
Press key to confirm, the scale returns to the weighing mode,
modified tare value with '–' sign is displayed.
You can enter tare value at any time during the weighing operation.
11.5. Dual Range Devices
Switching from weighing with the accuracy of the I weighing range to weighing
with the accuracy of the II weighing range takes place automatically upon
exceeding Max of the I weighing range. Upon switching to weighing with the
accuracy of the II weighing range, pictogram/marker is displayed in the
top left hand corner.
To return to weighing with the accuracy of the I weighing range:
unload the weighing pan,
when zero indication and , pictograms are displayed, press
key,
II weighing range pictogram/marker gets blank.
11.6. Units
<P9.Unit> parameter group enables change of start unit and temporary unit.
The unit can be changed to some other unit during weighing or during other
modes operation. 'Parts counting' and 'Percent weighing' modes are
exceptions.
11.6.1. Start Unit
Parameter for setting unit that is displayed and used after device start-up.
Procedure:
Enter <P9.Unit / 9.1.UnSt> submenu.
Press key, available units are displayed successively one by one.
Options in case when the main unit is [kg]: kg (kilogram), g (gram),
lb (pound)*, N (Newton).
To Next Page
Loading...
