RADWAG PUE C315

35
 Single part mass is calculated automatically, next quantity of parts (pcs)
is displayed.
Total weight value of all parts loaded onto the weighing pan
cannot be greater than the max capacity value.
Single part mass value must be equal or greater than 0.1
of the reading unit. Unless this condition is met, the
weighing device displays a message <Err Lo>.
In the course of parts quantity determination before
confirming the declared quantity value it is necessary to wait
for a stable measurement .
22. WORKING MODE - +/- CONTROL
+/- control is a working mode enabling you to enter values of the
checkweighing thresholds (Min, Max).
22.1. Local Settings
To go to local settings enter <3.3.HiLo> submenu.
3.3.1.Acc
Working mode accessibility
For detailed description read section 19.2.1.
3.3.2.Snn
Save mode
For detailed description read section 19.2.2.
3.3.3.Int
Time interval
For detailed description read section 19.2.3.
3.3.4.Lo
Lo threshold
For detailed description read section 19.2.4.
22.2. Declaring Checkweighing Thresholds
 Enter <HiLo> working mode (+/- control), first, text <SEt Lo> is displayed
for 1 s, next, window for declaring low weighing threshold (Min).
 Enter the value and press key to confirm, first, text <SEt Hi>
is displayed for 1 second, next, window for declaring high weighing
threshold (Max).
 Enter the value and press key to confirm, working mode's home
screen is displayed along with declared threshold value, where:
Min
Load mass lower than low weighing threshold.
Ok
Load mass within weighing thresholds.