Enter <toP> working mode (Peak Hold). From now on the scale registers
and holds every single weighting which is above the Lo threshold, and
which is higher than the result of the previous peak hold. Snapped peak
hold value is signalled by <Max> pictogram displayed at the top of the
screen.
The start of the next process of peak hold measurement is possible only
after removing the load from the weighing pan and pressing button.
This causes returning to the home screen of <toP> mode. Pictogram
<Max> is automatically deleted.
25. WORKING MODE - TOTALISING
Totalising is a working mode enabling you to sum mass of all weighed
ingredients, and to print (via scale-connected printer) the total mass value.
The program allows you to sum up to 30 weighings (ingredients) maximum
within one process.
25.1. Local Settings
To go to local settings enter <3.6.Add> submenu.
Working mode accessibility
For detailed description read section 19.2.1.
For detailed description read section 19.2.2.
For detailed description read section 19.2.3.
For detailed description read section 19.2.4.
25.2. Totalising Operation
Enter <Add> working mode (Totalising), blinking „▲” pictogram
is displayed.
If the ingredients are to be weighed in a container, first put the container
on a weighing pan and tare it.
Load the weighing pan with the ingredient no.1. When the indication
is stable ( pictogram is displayed) press key to confirm the mass.
Total mass value is displayed, now the „▲” pictogram is displayed
continuously.
Unload the weighing pan, ZERO is displayed, „▲” marker starts blinking
again.
To Next Page
Loading...
