RADWAG PUE C315

28
Procedure:
 Enter <P7.Othr / 7.1.bl> submenu.
 Press key, parameter values are displayed successively one by one:
nonE – function disabled, 0.5, 1, 2, 3, 5.
 Press key to confirm, next go to the home screen.
17.2. Display Brightness
Parameter allowing to change display brightness, the brightness can be
changed within 0% - 100% range.
Procedure:
 Enter <P7.Othr / 7.2.bLbt> submenu.
 Press key, parameter values are displayed successively one by one,
where:
nonE
Backlight off.
10
Display brightness low limit value in [%].
100
Display brightness high limit value in [%].
 Set the respective value, press key to confirm, next go to the home
screen.
17.3. 'Beep' Sound
Parameter allowing you to enable/disable sound signal informing the operator
about pressing panel key(s).
Procedure:
 Enter <P7.Othr / 7.3.bEEP> submenu.
 Press key, parameter values are displayed successively one by one:
no – sound signal disabled, YES - sound signal enabled.
 Set the respective value, press key to confirm, next go to the home
screen.