RADWAG PUE C315

33
20. WORKING MODE – WEIGHING
<UUGG> is a standard working mode enabling you to carry out weighing along
with record of the result to the database.
20.1. Local Settings
To go to local settings enter <3.1.UUGG> submenu.
3.1.1.Acc
Working mode accessibility
For detailed description read section 19.2.1.
3.1.2.Snn
Save mode
For detailed description read section 19.2.2.
3.1.3.Int
Time interval
For detailed description read section 19.2.3.
3.1.4.Lo
Lo threshold
For detailed description read section 19.2.4.
21. WORKING MODE – PARTS COUNTING
Parts Counting is a working mode enabling you to determine quantity of small
pieces of the same mass, which determination is done on the basis of mass of
sample piece (single part), and where the sample piece mass (single part
mass) is determined using the weighing device.
21.1. Local Settings
To go to local settings enter <3.2.PcS> submenu.
3.2.1.Acc
Working mode accessibility
For detailed description read section 19.2.1.
3.2.2.UUt
Operation mode
For detailed description read section 21.1.1.
3.2.3.Snn
Save mode
For detailed description read section 19.2.2.
3.2.4.Int
Time interval
For detailed description read section 19.2.3.
3.2.5.Lo
Lo Threshold
For detailed description read section 19.2.4.
21.1.1. Selecting Operation Mode
Parameter allowing you to select method of determination of sample piece
mass.
Procedure:
 Enter <3.2.PcS / 3.2.2.UUt> submenu.
 Press key, parameter values are displayed successively one by one: