26. WORKING MODE – ANIMAL WEIGHING
Animal Weighing is a working mode enabling you to weigh products that disrupt
efficient establishing of stability. It is mostly intended to measure weight of
animals.
26.1. Local Settings
To go to local settings enter <3.7.AnLS> submenu.
Working mode accessibility
For detailed description read section 19.2.1.
Enter this parameter to declare duration of the
process in seconds (5s, 10s, 20s, 30s, 40s, 50s,
60s) - on the basis of indications recorded within
the set time interval the scale calculates the
weighing result, i.e. an average weight value.
For detailed description read section 19.2.4.
26.2. Animal Weighing Operation
Enter <AnLS> working mode (Animal Weighing).
First text <tinnE> is displayed for 1 s, next, window for setting duration
(in seconds) of animal weighing.
Press key, parameter values are displayed successively one by one:
5[s], 10[s], 20[s], 30[s], 40[s], 50[s], 60[s].
Set the respective value, press key to confirm, weighing window with
A letter is displayed.
Load the weighing pan with an animal.
On exceeding the set mass value of <Lo> threshold parameter, animal
weighing starts, this is signalled with display of 'dash', < - >.
Upon process completion mass value of an animal is snapped and
displayed together with OK pictogram in the upper part of the display.
The snapped mass value is sent to a scale-connected printer.
Press key to restart animal weighing.
Press key to reprint the snapped mass value.
Upon unloading of the weighing platform, the weighing window with letter
A is displayed. The scale can be loaded with an animal again.
To Next Page
Loading...
