Procedure:
Enter <P2.rEAd / 2.4.Aut> submenu.
Press key, parameter values are displayed successively one by one:
YES – autozero function enabled, no – autozero function disabled.
Set the respective value, press key to confirm, next go to the home
screen.
13.5. Tare Function
'Tare' function has been designed to enable setup of appropriate parameters
for tare operation.
Procedure:
Enter <P2.rEAd / 2.5.tArE> submenu.
Press key, available values are displayed successively one by one:
Regular tare mode. Select this parameter to make the scale overwrite the set
(selected) tare value with the most recently entered one.
Select this parameter to make the scale store the latest tare value in memory.
The latest tare value is displayed after scale restart.
Select this parameter to make the scale automatically tare each accepted
measurement.
Press key to confirm, next go to the home screen.
13.6. Tare Entering Mode
The tare is entered using + keys combination from the home screen
level. There are two enter modes.
Procedure:
Enter <P2.rEAd / 2.6.ttr> submenu.
Press key, parameter values are displayed successively one by one:
To Next Page
Loading...
