RADWAG PUE C315

31
19.2. Working Modes Local Settings
Each working mode features specific functions which enable adapting device
operation to individual needs. To go to local settings of each working mode
enter <P3.Func> submenu.
Some special functions are available for all working modes, refer to the table
below:
Accessibility
Save mode
Time interval
Lo threshold
Weighing
3.1.1.Acc
3.1.2.Snn
3.1.3.Int
3.1.4.Lo
Parts counting
3.2.1.Acc
3.2.3.Snn
3.2.4.Int
3.2.5.Lo
+/- control
3.3.1.Acc
3.3.2.Snn
3.3.3.Int
3.3.4.Lo
Percent weighing %
3.4.1.Acc
3.4.3.Snn
3.4.4.Int
3.4.5.Lo
Peak Hold
3.5.1.Acc
-
-
3.5.2.Lo
Totalizing
3.6.1.Acc
3.6.2.Snn
3.6.3.Int
3.6.4.Lo
Animal weighing
3.7.1.Acc
-
-
3.7.3.Lo
The table presents special function number and name for each of the working
modes. Remaining specific functions referring directly to a given working mode
are described further down this user manual.
19.2.1. Working Mode Accessibility
To enable/disable given working mode, press key.
Procedure:
 Enter <P3.Func> menu and select given working mode.
 Go to <Acc> function.
 Press key, parameter values are displayed successively one by one:
YES – working mode enabled, no – working mode disabled.
 Set the respective value, press key to confirm, next go to the home
screen.
19.2.2. Save Mode
Parameter allowing you to set mode of sending data from the weighing device
to a peripheral device.