Radware Alteon Installation and Maintenance Guide
Maintenance and Software Upgrade
68 Document ID: RDWR-ALOS-V2815_IG0203
• password is the password you receive from Radware Technical Support, based on the Base
MAC address of the platform.
Notes
>> Alteon issues messages regarding throughput limits to the console, Telnet, SSH
interfaces, and syslog.
>> Alteon issues messages when the current throughput is approaching the limit of the
throughput licence. The severity of this message in syslog, for example, is LOG_ALERT.
You can configure the threshold at which the device starts sending these messages. The
value for the parameter is a percentage of the maximum throughput. Values: 0, 1–99
(0—the device never sends the messages). Default is 90.
>> Alteon issues messages when the current throughput has exceeded the limit defined by
the license. The severity of this message in syslog, for example, is LOG_CRIT. The
frequency for these messages is determined by the throughput-threshold detection
interval, which you can configure. Values: 1–1440 (minutes). Default is 1 (minute). If,
during any one interval, the threshold is reached and then goes back to under the limit,
the device still sends a message when the interval elapses.
>> Alteon Application Switch issues messages when throughput returns to below the limit.
Checking License Status
You can view license information using the /info/swkey command. The following is an example
display:
Throughput License: 40Gbps
Permanent License: aas-cookie-ESRV-28-MXRxnVDz
vADC License: aas-vadc-3-xAhIwQNO
Allocated Capacity units: 10(28)
Available system Throughput: 39.90G
SSL License: Default
Available system SSL: 500CPS
Compression License: Default
Available system Compression: 100MB
Software feature Status
---------------- ------
slb Permanent
Services (0/0) Permanent
vadc (1/20) Permanent
vADC Thrput (Mb) SSL Compression Features
------- ------------- ---------- ------------- ----------
28 200 0 0 global, bwm
To Next Page
Loading...
Need help?
General