What to do if a port Link LED (green) does not light on a Radware Controller?
If the port is configured with a specific speed or duplex mode, ensure the other device is set to the same configuration. If the port is configured to auto-negotiate, make sure the other device is also set to auto-negotiate. This issue is due to a port configuration mismatch between two devices or a cable problem.
Why is my Radware Controller unable to contact the specified TFTP or FTP server?
If the Radware Controller device is unable to contact the specified TFTP or FTP server and download files, ensure that the network connection and TFTP or FTP server are functioning properly. If the problem is with the software, perform a serial upgrade of the software. The cause of this problem may be related to a problem with the network connection, the TFTP or FTP server, or with the software.
What to do if the CLI command prompt does not appear on a Radware Controller?
If the CLI command prompt does not appear after the establishment of a connection through the console, Telnet, or SSH on your Radware Controller, upgrade the operating system of the software. This issue can be caused by the operating system being damaged.
How to fix poor performance on Radware Alteon Application Switch 4408. 4416?
Reconnect the cables to dedicated cores for uplink and downlinks. This poor performance may be caused because the same core is used for uplink and downlink.
What to do if Radware Controller cannot install an application?
If the Radware Controller device cannot install an application and issues an error message before powering off, remove the TAR files from the USB device. Add a new TAR file to the USB and reboot. If the error persists, it is a hardware issue; contact Radware Technical Support. This may be happening because no valid application was found, the TAR file on the USB device includes an invalid application, or there is a hardware problem.
What to do if the application started on Radware Controller, but a warning was printed?
Restart the Radware Controller device. An ordinary upgrade process is also available. The warning may be caused by some minor mismatch in configuration.
Why is the IS LED blue on my Radware Controller?
This LED will blink a few times and turn off after a few seconds (~20 on nodes). The slot may not be fully inserted or the slot is initializing.
What to do if the H/S LED is showing a blue light after a blade has been inserted into Radware Controller?
Try to install again. The installation may have failed.
General| Model | Alteon |
|---|---|
| Manufacturer | Radware |
| Layer | Layer 4-7 |
| Type | Application Delivery Controller (ADC) |
| Features | Load balancing, SSL offloading, application acceleration, DDoS protection |
| Form Factor | Virtual Appliance |
To Next Page
