Radware Alteon User Manual

Alteon Application Switch Operating System Application Guide
Routing Information Protocol
124 Document ID: RDWR-ALOS-V2900_AG1302
For maximum security, RIPv1 messages are ignored when authentication is enabled. If not, the
routing information from authenticated messages is propagated by RIPv1 routers in an
unauthenticated manner.
RIP Configuration Example
Note: A disabled RIP interface uses all the default values of the RIP, no matter how the RIP
parameters are configured for that interface. RIP sends RIP regular updates to include an up
interface, but not a down interface.
1. Add VLANs for routing interfaces.
2. Add IP interfaces to VLANs.
3. Turn on RIP globally and enable RIP for each interface.
4. Use the /maint/route/dump command to check the current valid routes in the routing table.
For those RIP-learned routes within the garbage collection period, routes phasing out of the
routing table with metric 16, use the
/info/l3/route/dump command. Locally configured
static routes do not appear in the RIP routing table.
>> Main# cfg/l2/vlan 2/ena
(Enable VLAN 2)
>> VLAN 2# add 2
(Add port 2 to VLAN 2)
Port 2 is an UNTAGGED port and its current PVID is 1.
Confirm changing PVID from 1 to 2 [y/n]: y
>> VLAN 2# /cfg/l2/vlan 3/ena
(Enable VLAN 3)
>> VLAN 3# add 3
(Add port EXT3 to VLAN 3)
Port 3 is an UNTAGGED port and its current PVID is 1.
Confirm changing PVID from 1 to 3 [y/n]: y
>> Main# cfg/l3/if 2/ena
(Enable interface 2)
>> IP Interface 2# addr 102.1.1.1
(Define IP address for interface 2)
>> IP Interface 2# vlan 2
(Add interface 2 to VLAN 2)
>> IP Interface 2# /cfg/l3/if 3/ena
(Enable interface 3)
>> IP Interface 3# addr 103.1.1.1
(Define IP address for interface 3)
>> IP Interface 3# vlan 3
(Add interface 3 to VLAN 3)
>> Main# cfg/l3/rip on
(Turn on RIP globally)
>> Routing Information Protocol# if 2/ena
(Enable RIP on IP interface 2)
>> RIP Interface 2# ..
>> Routing Information Protocol# if 3/ena
(Enable RIP on IP interface 3)
>> RIP Interface 3# apply
(Apply your changes)
>> RIP Interface 3# save
(Save the configuration)

Radware Alteon Specifications

General

Model	Alteon
Manufacturer	Radware
Layer	Layer 4-7
Type	Application Delivery Controller (ADC)
Features	Load balancing, SSL offloading, application acceleration, DDoS protection
Form Factor	Virtual Appliance