Alteon Application Switch Operating System Application Guide
ADC-VX Management
450 Document ID: RDWR-ALOS-V2900_AG1302
Note: Images inherited from a standalone ADC that are not compatible with ADC-VX display in the
ADC application repository as incompatible.
Switching Between System Modes
The factory-installed Alteon image supports both ADC-VX and standalone modes. You can switch
between these two modes using a single command.
There are two options for switching between modes:
• Standalone to ADC-VX—The administrator selects an ADC-VX infrastructure image from which
to boot.
• ADC-VX to Standalone—The administrator selects an ADC application image.
Regardless of the mode which is booted, the system does not delete old configuration files.
Caution: If you remove all infrastructure images, the image switching process cannot be initiated.
Switching from Standalone to ADC-VX Mode
Switching from standalone to ADC-VX mode includes both the software and the configuration files.
The following boot options are available::
• Boot with factory defaults
• Boot with the last known configuration
When booting with the last known configuration, the image IDs stored in the configuration file are
used. If the image bank is empty, the assigned default image is used. The last known ADC-VX
configuration includes both AC settings and vADCs.
Table 39: Image Status Options
Status Option Description
Incompatible Image is only compatible with standalone mode and not in use.
Active The currently active image in the system
Assigned Image is assigned to a vADC that is not active
Idle Image is idle and not assigned to a vADC or any other system component
To Next Page
Loading...
Need help?
General