Alteon Application Switch Operating System Application Guide
XML Configuration API
Document ID: RDWR-ALOS-V2900_AG1302 797
XML Configuration
The following is an example procedure to enable and use the XML Configuration API.
To use the XML configuration feature
Note: All CLI commands with an enable option also have a corresponding disable option.
1. Globally enable XML configuration. The XML Configuration API is disabled by default. To enable
this feature, enter the following command:
2. Optionally, set the XML transport port number. Since SSL is the transport mechanism for the
XML configuration file, the port used by Alteon to receive these files is the SSL port by default.
You can change the default by using the following command:
Note: Since both HTTPS and XML use SSL as a transport layer, the two are closely tied
together. Both HTTPS and XML must use the same port if both are enabled.
3. Import client certificate. Certificate authentication is required to send an XML configuration file
to Alteon. To import a client certificate, do the following:
After entering the required information, the client certificate is downloaded to Alteon.
Additional Feature Commands
The following commands are used to maintain and monitor the XML Configuration API:
To delete the client certificate
>> Main# /cfg/sys/access/xml/xml enable
>> Main# /cfg/sys/access/xml/port <port number>
>> Main# /cfg/sys/access/xml/gtcert <TFTP/FTP IP Address>
<Certificate File Name> <FTP User Name> <FTP Password>
>> Main /cfg/sys/access/xml/delcert
To Next Page
Loading...
Need help?
General