Radware Alteon User Manual

Alteon Application Switch Operating System Application Guide
High Availability
Document ID: RDWR-ALOS-V2900_AG1302 573
c. Configure the backup as a peer and specify its IP address.
2. On the backup Alteon:
a. Enable stateful failover.
b. Set the update interval. The default is 30.
The update does not have to be the same for both Alteons. Stateful failover supports up to
two peers. Repeat the steps mentioned above to enable stateful failover on all the peers.
c. Configure the master as a peer and specify its IP address.
Viewing Statistics on Persistent Port Sessions
You can view statistics on persistent port sessions using the /stats/slb/ssl command. To
determine which Alteon is the master and which is the backup, use the
/info/l3/vrrp command.
The column on the far right displays Alteon status.
• If Alteon is a master:
• If Alteon is a backup:
>> Main # /cfg/slb/sync
>> Config Synchronization # peer 1
(Select a peer)
>> Peer Switch 1 # addr 10.1.1.2
(Assign backup Alteon IP address)
>> Peer Switch 1 # enable
(Enable peer Alteon)
>> Main # /cfg/slb/sync/state ena
>> Main # /cfg/slb/sync/update 10
>> Main # /cfg/slb/sync
>> Config Synchronization # peer 2
(Select a peer)
>> Peer Switch 2 # addr 10.1.1.1
(Assign master Alteon IP address)
>> Peer Switch 2 # enable
(Enable peer Alteon)
>> Main # /info/l3/vrrp
VRRP information:
1: vrid 1, 172.21.16.187,if 4, renter, prio 109, master, server
3: vrid 3, 192.168.1.30, if 2, renter, prio 109, master
5: vrid 5, 172.21.16.10, if 4, renter, prio 109, master
>> Main # /info/l3/vrrp
VRRP information:
1: vrid 1, 172.21.16.187,if 1, renter, prio 104, backup, server
3: vrid 3, 192.168.1.30, if 3, renter, prio 104, backup
5: vrid 5, 172.21.16.10, if 1, renter, prio 104, backup

Radware Alteon Specifications

General

Model	Alteon
Manufacturer	Radware
Layer	Layer 4-7
Type	Application Delivery Controller (ADC)
Features	Load balancing, SSL offloading, application acceleration, DDoS protection
Form Factor	Virtual Appliance