Alteon Application Switch Operating System Application Guide
Server Load Balancing
218 Document ID: RDWR-ALOS-V2900_AG1302
Implementing HTTP/HTTPS Server Load Balancing
This section includes the following topics:
• Procedures for Common HTTP and HTTPS Implementations, page 218
• HTTP/S Services Features, page 219
Procedures for Common HTTP and HTTPS Implementations
Use the following commands for common HTTP and HTTPS implementations.
To configure Alteon for HTTP load balancing on its well-known port (80)
Access the virtual server, and set the HTTP virtual service.
To configure Alteon for HTTPS load balancing on its well-known port (443)
Access the virtual server, and set the HTTPS virtual service.
To configure HTTP or HTTPS on a non-standard port
Use the same command with the requested port number. Alteon prompts you for the application for
which you want to use this port (assuming it is not the well-known port of another application).
To configure Alteon for HTTP load balancing on port 88 (non-standard port)
Access the virtual server, and set the HTTP virtual service.
To configure Alteon for HTTPS load balancing on port 444 (non-standard port)
Access the virtual server, and set the HTTP virtual service.
>> /cfg/slb/virt 1/service http
>> /cfg/slb/virt 1/service https
>> /cfg/slb/virt 1/service 88 http
>> /cfg/slb/virt 1/service 444 https
To Next Page
Loading...
Need help?
General