Radware Alteon - Configuring LDAP SLB

Alteon Application Switch Operating System Application Guide
Load Balancing Special Services
Document ID: RDWR-ALOS-V2900_AG1302 283
To enable a session reset for a virtual server that is running the LDAP service
Figure 41 - LDAP Load Balancing, page 283 shows four LDAP servers load balancing LDAP queries:
Figure 41: LDAP Load Balancing
Configuring LDAP SLB
This procedure references Figure 41 - LDAP Load Balancing, page 283.
To configure LDAP SLB
1. Enable SLB.
2. Configure the four real LDAP servers and their real IP addresses.
>> # /cfg/slb/virt 1/service ldap/reset enable
>> # /cfg/slb/on
>> # /cfg/slb/real 20
>> Real server 20 # ena
(Enable Real Server 20)
>> Real server 20 # rip 10.10.10.20
(Specify the IP address)
>> Real server 20 # layer7/
(Select the Layer 7 menu)
>> Real Server 20 Layer 7 Commands# ldapwr e
(Enable LDAP read-write)