EasyManuals Logo

Radware Alteon User Manual

Radware Alteon
842 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #128 background imageLoading...
Page #128 background image
Alteon Application Switch Operating System Application Guide
Border Gateway Protocol
128 Document ID: RDWR-ALOS-V2900_AG1302
Precedence
You can set a priority to a route map by specifying a precedence value with the following command:
The lower the value, the higher the precedence. If two route maps have the same precedence value,
the lower number has higher precedence.
Configuration Overview
To configure route maps
1. Define the network filter.
Enter a filter number from 1 to 256. Specify the IP address and subnet mask of the network that
you want to match. Enable the network filter. You can distribute up to 256 network filters among
32 route maps each containing eight access lists.
2. Optionally, define the criteria for the access list and enable it.
Specify the access list and associate the network filter number configured in step 1.
This step and step 3
are optional, depending on the criteria that you want to match. In this step,
the network filter number is used to match the subnets defined in the network filter. In step 3
,
the autonomous system number is used to match the subnets. Alternately, you can use both
step 2
and step 3 criteria (access list [network filter] and access path [AS filter]) to configure
the route maps.
3. Optionally, configure the attributes in the AS filter menu.
>> /cfg/l3/rmap <x> /pre
(Specify a precedence)
>> # /cfg/l3/nwf 1
(Specify a network filter number)
>> IP Network Filter 1# addr <IP address>
(Specify network address)
>> IP Network Filter 1# mask <IP mask>
(Specify network mask)
>> IP Network Filter 1# ena
(Enable network filter)
>> # /cfb/13/rmap 1
(Specify a route map number)
>> IP Route Map 1# alist 1
(Specify the access list number)
>> IP Access List 1# nwf 1
(Specify the network filter number)
>> IP Access List 1# metric
(Define a metric)
>> IP Access List 1# action deny
(Specify action for the access list)
>> IP Access List 1# ena
(Enable the access list)
>> # cfg/13/rmap 1/aspath
(Specify the attributes in the filter)
>> AS Filter 1# as 1
(Specify the AS number)
>> AS Filter 1# action deny
(Specify the action for the filter)
>> AS Filter 1# ena
(Enable the AS filter)

Table of Contents

Other manuals for Radware Alteon

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Radware Alteon and is the answer not in the manual?

Radware Alteon Specifications

General IconGeneral
ModelAlteon
ManufacturerRadware
LayerLayer 4-7
TypeApplication Delivery Controller (ADC)
FeaturesLoad balancing, SSL offloading, application acceleration, DDoS protection
Form FactorVirtual Appliance