EasyManuals Logo

Radware Alteon User Manual

Radware Alteon
842 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #306 background imageLoading...
Page #306 background image
Alteon Application Switch Operating System Application Guide
Load Balancing Special Services
306 Document ID: RDWR-ALOS-V2900_AG1302
6. Enable TPCP for adding and deleting WAP sessions.
7. Configure the following filter on Alteon to examine a RADIUS accounting packet. Set the basic
filter parameters
8. Enable proxy and RADIUS snooping.
9. Apply and save your configuration.
Note: Alteon supports Virtual Router Redundancy Protocol (VRRP) and stateful failover, using
both static session entries and RADIUS snooping. However, the active-active configuration with
stateful failover is not supported.
WAP SLB with RADIUS/WAP Persistence
This feature enables RADIUS and WAP persistence by binding both RADIUS accounting and WAP
sessions to the same server.
A WAP client is first authenticated by the RADIUS server on UDP port 1812. The server replies with a
RADIUS accept or reject frame. Alteon forwards this reply to the RAS. After the RAS receives the
RADIUS accept packet, it sends a RADIUS accounting start packet on UDP port 1813 to the bound
server. Alteon snoops on the RADIUS accounting start packet for the framed IP address attribute.
The framed IP address attribute is used to rebind the RADIUS accounting session to a new server.
>> # cfg/slb/wap/tpcp ena
>> # /cfg/slb/filt 1
(Select the filter)
>> Filter 1 # ena
(Enable the filter)
>> Filter 1 # dip 10.10.10.100
(Set the destination IP address)
>> Filter 1 # dmask 255.255.255.255
(Set the destination IP mask)
>> Filter 1 # proto udp
(Set the protocol to UDP)
>> Filter 1 # dport 1813
(Set the destination port)
>> Filter 1 # action redir
(Set the action to redirect)
>> Filter 1 # group 1
(Set the group for redirection)
>> Filter 1 # rport 1813
(Set server port for redirection)
>> Filter 1 # adv
(Select the Advanced Filter menu)
>> Filter 1 Advanced# proxy ena
(Enable proxy)
>> Filter 1 Advanced# layer7
(Select the Layer 7 Advanced menu)
>> Layer 7 Advanced# rdsnp ena
(Enable RADIUS snooping)
>> Layer 7 Advanced# apply
>> Layer 7 Advanced# save

Table of Contents

Other manuals for Radware Alteon

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Radware Alteon and is the answer not in the manual?

Radware Alteon Specifications

General IconGeneral
ModelAlteon
ManufacturerRadware
LayerLayer 4-7
TypeApplication Delivery Controller (ADC)
FeaturesLoad balancing, SSL offloading, application acceleration, DDoS protection
Form FactorVirtual Appliance