Alteon Application Switch Operating System Application Guide
Load Balancing Special Services
Document ID: RDWR-ALOS-V2900_AG1302 305
Configuring WAP SLB using RADIUS Snooping
This procedure references Figure 46 - Load Balancing WAP Gateways, page 301.
To configure WAP SLB using RADIUS snooping
1. Before you start configuring WAP load balancing:
— Enable Layer 3 server load balancing.
— Enable UDP under the WAP services (ports 9200 to 9203) menu.
— Configure for RADIUS services 1812, 1813, and 1645.
Note: The RADIUS service number specified on Alteon must match the service specified on the
server.
2. Configure Alteon for basic SLB.
3. Configure IP addresses for the RADIUS/WAP gateways.
4. Create a group to load balance the WAP gateways.
5. Enable the external notification from WAP gateway to add and delete session requests if you are
using static session via TPCP.
>> # /cfg/slb/virt <number> /layr3 ena
>> # /cfg/slb/virt <number> /service <name|number> /protocol udp
>> # /cfg/slb/virt <number> /service <name|number> /protocol udp
>> # /cfg/slb/on
>> # /cfg/slb/real 1/rip 1.1.1.100
(Define address for WAP Gateway1)
>> Real server 1# ena
(Enable Real Server 1)
>> # /cfg/slb/real 2/rip 2.2.2.100
(Define address for WAP Gateway 2)
>> Real server 2# ena
(Enable Real Server 2)
>> # /cfg/slb/real 3/rip 3.3.3.100
(Define address for WAP Gateway 3)
>> Real server 3# ena
(Enable Real Server 3)
>> # /cfg/slb/group 100
(Define a group)
>>Real Server Group 100# add 1
(Add Real Server 1)
>>Real Server Group 100# add 2
(Add Real Server 2)
>>Real Server Group 100# add 3
(Add Real Server 3)
>> # cfg/slb/adv/tpcp ena
To Next Page
Loading...
Need help?
General