Radware Alteon User Manual

Alteon Application Switch Operating System Application Guide
Application Redirection
472 Document ID: RDWR-ALOS-V2900_AG1302
When the proto parameter is not tcp or udp, then sport and dport are ignored.
13. Turn on filtering for the port.
14. Add the filters to the client port.
15. Enable Direct Access Mode (DAM).
16. Enable, apply, and verify the configuration.
Viewing Statistics for URL-Based Cache Redirection
To show the number of hits to the cache server or origin server, use the following command:
HTTP Header-Based Cache Redirection
This procedure is an example configuration for HTTP header-based cache redirection.
To configure Alteon for cache direction based on the "Host:" header
1. Before you can configure header-based cache redirection, ensure that Alteon is configured for
basic SLB (see Server Load Balancing, page 165
):
— Assign an IP address to each of the real servers in the server pool.
>> Filter <filter number> # ena
(Enable the default filter)
>> Filter <filter number> # port <port
number>
(Assign the default filter to a port)
>> SLB <port number> # filt ena
>> SLB <port number> # add <filter number>
>> SLB <port number> # /cfg/slb/adv
>> Layer 4 Advanced# direct ena
>> # /cfg/slb
(Select the SLB menu)
>> # on
(Turn SLB on)
>> # apply
(Make your changes active)
>> # cur
(View current settings)
>> # /stats/slb/layer7/redir
Total URL based Web cache redirection stats:
Total cache server hits: 73942
Total origin server hits: 2244
Total straight to origin server hits: 0
Total none-GETs hits: 53467
Total 'Cookie: ' hits: 729
Total no-cache hits: 43
Total RTSP cache server hits: 0
Total RTSP origin server hits: 0
Total HTTP redirection hits: 0

Radware Alteon Specifications

General

Model	Alteon
Manufacturer	Radware
Layer	Layer 4-7
Type	Application Delivery Controller (ADC)
Features	Load balancing, SSL offloading, application acceleration, DDoS protection
Form Factor	Virtual Appliance