Alteon Application Switch Operating System Application Guide
Securing Alteon
Document ID: RDWR-ALOS-V2900_AG1302 71
• SSH Communications Vandyke SSH A
• F-Secure
Note: There can be a maximum number of four simultaneous Telnet, SSH, SCP connections at one
time. The
/cfg/sys/radius/telnet command also applies to SSH/SCP connections.
Configuring SSH and SCP Features
You can configure SSH and SCP parameters via the console port only, using the CLI. However, SCP
putcfg and TFTP getcfg can also change the SSH and SCP configurations. When you enable SSH,
SCP is also enabled. The Alteon SSH daemon uses TCP port 22 only and is not configurable.
Before you can use SSH commands, you must turn on SSH and SCP.
To enable or disable SSH
1. To enable SSH:
2. To disable SSH:
To enable or disable SCP putcg_apply and putcg_apply_save
1. To enable SCP putcfg_apply and putfg_apply_save:
>> Main# /cfg/sys/access/sshd/on
Current status: OFF
New status: ON
>> Main# /cfg/sys/access/sshd/off
Current status: ON
New status: OFF
>> # /cfg/sys/access/sshd/ena
(Enable SCP apply and save)
SSH Server# apply
(Apply the changes to start generating RSA host
and server keys)
RSA host key generation starts
..............................................................................
.....................................
RSA host key generation completes (lasts 212549 ms)
RSA host key is being saved to Flash ROM, please don't reboot
the box immediately.RSA server key generation starts
............................................................
RSA server key generation completes (lasts 75503 ms)
RSA server key is being saved to Flash ROM, please don't reboot
the box immediately.
------------------------------------------------------------------
Apply complete; don't forget to "save" updated configuration.
To Next Page
Loading...
Need help?
General