Radware Alteon Installation and Maintenance Guide
Specifications
90 Document ID: RDWR-ALOS-V2815_IG0203
Figure 18: Radware’s Alteon VA and VADI Architecture
Alteon ADC provides ADC virtualization with ADC-VX, the ADC virtualization and consolidation
platform based on a specialized ADC hypervisor. ADC-VX is built on architecture that virtualizes the
resources of the Alteon ADC platform including CPU, memory, network and acceleration resources.
This specialized hypervisor runs fully functional virtual ADC instances, each of which delivers ADC
functionality just like a dedicated physical ADC device. Each virtual ADC instance contains a
complete and separated environment of resources, configurations, and management.
Notes
>> Alteon 5224 devices running ADC-VX require 24 GB of RAM, and therefore need a
memory upgrade from the default 6 GB to 24 GB. Other memory configurations do not
allow you to use ADC-VX.
>> Alteon 5224 XL devices require 24 GB of RAM and therefore need an upgrade from 12
GB to 24 GB. The default 12 GB does not support ADC-VX.
>> For further information on the 5224 and 5224 XL platforms, see Alteon Application
Switch Specifications, page 77.
Layer 2 Features
Alteon Application Switches support the following Layer 2 features:
• VLAN
• STP (MSTP/RSTP)
• Trunk groups
• LACP
• Port team
Related Specifications
For additional information, refer to the following table for related specifications. Note that while
these sources have been verified, the information is subject to change without notice.
To Next Page
Loading...
Need help?
General