Raise3D Pro3 HS Series Printer User Manual Main Parts
13
The upper cover of the printer.
The part extruding filament to the hot end. Brand-new unitized extruders, which are more
convenient for assembly and dismounting are featured on this printer. The printer’s dual
extrusion structure can adapt to a variety of filaments.
The part used to cool the heat down.
The part that melts filaments. With a quick-release design, even beginners can quickly
remove the hot end within one minute, making it more convenient to repair the hot end
after removing it.
The part that you can control the printer and check the printer status.
A plate for printing the model.
The part used to observe the operation of the printer.
The part that protects and guides filaments.
The integrated cable that transmits the signal from the motion controller board to the
extruder. A new flat cable is adopted to replace the large drag chain of Pro2 series printers,
reducing the weight of the extruder and avoiding the sagging of the cross shaft.
J. Filament Run-out Sensor
An automated optical detection system is adopted to detect whether the filaments are
sufficient. When the filaments are running out, the printer will automatically stop printing.
Uses RFID tags and readers for information transmission and identification
between the printer and filaments.
An air filter manager including a fan and a HEPA filter, which is used to enhance air
circulation inside the printer.
The place where the filament is discharged, which can accommodate 2 spools of 1kg
filaments at the same time.
N. Electric Control System
To Next Page
