Raise3D Pro3 HS Series - Page 17

Raise3D Pro3 HS Series Printer User Manual Main Parts
14
It stores the motion controller board.
O. USB Interface
2 USB2.0 interfaces.
P. Ethernet Port
RJ45 is connected to the port to connect your printer to a network.
Note: The length of the network cable should not exceed 3 m.
Q. Power Inlet
The place to connect power cable.
R. Switch
The power switch to turn on/off the printer.
S. Casters
Four swiveling and double-locking casters.
Hyper Speed Hot End