Operating Manual 1302.6163.12 - 03 4.79
R&S ESU Instrument Functions
IF Spectrum Analysis Mode
IF
The IF hotkey selects the IF analysis mode (IF spectrum analysis) and activates the
menu for setting the main parameters.
Remote command: INST IFAN
RECEIVER
FREQUENCY
The RECEIVER FREQUENCY softkey activates the entry field of the receiver fre-
quency.
For further information refer to the descriptions in section “Receiver Mode” –
“RECEIVER FREQUENCY” on page 4.14 (FREQ menu).
ADD TO PEAK
LIST
The ADD TO PEAK LIST softkey adds the receiver frequency of the current marker
to the peak list.
For further information refer to the descriptions in section “Receiver Mode” – “ADD
TO PEAK LIST” on page 4.27 (MKR menu).
DETECTOR
The DETECTOR softkey opens a submenu to select the detector and combinations
of detectors.
For further information refer to the descriptions in section “Receiver Mode” –
“DETECTOR” on page 4.29 (MEAS menu).
MEAS TIME
The MEAS TIME softkey activates the entry field for the measurement time.
For further information refer to the descriptions in section “Receiver Mode” – “MEAS
TIME” on page 4.31 (MEAS menu).
DEMOD
The DEMOD softkey calls a submenu in which the desired type of demodulation can
be switched on.
For further information refer to the descriptions in section “Receiver Mode” –
“DEMOD” on page 4.33 (MEAS menu).
FINAL MEAS
The FINAL MEAS softkey opens a submenue where conditions for measurement
can be set and the final measurement can be started.
For further information refer to the descriptions in section “Receiver Mode” – “FINAL
MEAS” on page 4.38 (MEAS menu).
RECEIVER FREQUENCY
ADD TO PEAK LIST
DETECTOR
!
MEAS TIME
DEMOD
!
FINAL MEAS!
IF RBW
SPAN MANUAL
To Next Page
Loading...
