R&S ESU Instrument Functions
Basic Settings
4.254 Operating Manual 1302.6163.12 - 03
The active window is marked by or on the right of the diagram.
Remote command: DISP:FORM SING
DISP:WIND<1|2>:SEL
SPLIT
SCREEN
The SPLIT SCREEN softkey selects the display of two diagrams. The upper dia-
gram is designated SCREEN A, the lower diagram SCREEN B.
Switching between SCREEN A and SCREEN B is performed via the corresponding
key in the hotkey bar. The active window is marked by highlighting fields and
on the right of the diagram.
In receiver mode, screen A displays the receiver bar graph and screen B the scan
diagram or the IF analysis diagram.
Remote command: DISP:FORM SPL
PARAM
COUPLING
The PARAM COUPLING softkey opens a submenu and a table to select the coupled
parameters of receiver and analyzer mode.
All analyzer traces in MAX HOLD, MIN HOLD or AVERAGE mode are set to VIEW
after switching to receiver or mixed mode and back to analyzer mode.
Limit lines keep active when switching between analyzer and receiver mode.
COUPLING
TABLE
The COUPLING TABLE softkey opens the PARAMETER COUPLING table.
Remote command:
A
B
A
B
COUPLING TABLE
DEFAULT CONFIG
ENABLE ALL ITEMS
DISABLE ALL ITEMS
Analyzer Center INST:COUP:CENT ALL
Start-Stop INST:COUP:SPAN ALL
Attenuation, Unit INST:COUP:ATT ALL
To Next Page
Loading...
