Operating Manual 1302.6163.12 - 03 4.301
R&S ESU Instrument Functions
Basic Settings
EDIT FILE
NAME
The EDIT FILE NAME softkey sets the focus on the File Name field and.
In the Save dialog box, the field already contains a suggestion for a new name: the
file name used in the last saving process is counted up to the next unused name.
For example, if the name last used was "test_004", the new name "test_005" is sug-
gested, but only if this name is not in use. If the name "test_005" is already in use,
the next free name is suggested, e.g. "test_006". You can change the suggested
name to any name conform to the following naming conventions.
The name of a settings file consists of a base name followed by an underscore and
three numbers, e.g. "limit_lines_005". In the example, the base name is "limit_lines".
The base name can contain characters, numbers and underscores. The file exten-
sion is added automatically and can not be changed.
EDIT
COMMENT
The EDIT COMMENT softkey activates the entry of commentary concerning the cur-
rent data set. The focus is set on the Comment field and an on-screen keyboard
opens.
Remote command: MMEM:COMM "Setup for FM measurement"
SELECT ITEMS The SELECT ITEMS softkey moves the selection bar to the first line, left column of
the Items field. An entry is selected. Position the entry focus to the corresponding
partial data set using the cursor keys and then press the ENTER key in the desired
line. The selection is cleared by pressing the key again.
The following submenu is opend:
Remote command: MMEM:SEL:HWS ON (Current Settings)
MMEM:SEL:LIN:ALL ON (All Limit Lines)
MMEM:SEL:TRAC ON (All Traces)
MMEM:SEL:SCD ON (Source Cal Data)
MMEM:SEL:TRAN:ALL ON (All Transducers)
MMEM:SEL:FIN ON (Peak/Final List)
MMEM:SEL:CLISt ON (Scan Channel List)
Note that the command MMEM:SEL:SCD ON (Source Cal Data) is only available
with option R&S ESU-B09 or R&S ESU-B10.
For further information on how to enter the comment text via the front panel of the
unit, see the Quick Start Guide, chapter 4, “Basic Operation”.
SELECT ITEMS
ENABLE ALL ITEMS
DISABLE ALL ITEMS
To Next Page
Loading...
