R&S ESU Remote Control – Description of Commands
HCOPy Subsystem
6.120 Operating Manual 1302.6163.12 - 03
HCOPy:MODE SCReen | TREPort:
This command selects the type of output that is used to document the measurements.
SCReen outputs the information that is visible on the screen in a graphical format.
TREPort prepares a configurable collection of measurement results and the instrument settings that
had an influence on the measurement results.
Example: ":HCOP:MODE SCR"
Characteristics: *RST value: SCR
SCPI: device-specific
Mode: R, A
HCOPy:PAGE:ORIentation<1|2> LANDscape | PORTrait
The command selects the format of the output (portrait and landscape) (hardcopy unit 1 or 2).
Example: "HCOP:PAGE:ORI LAND"
Characteristics: *RST value: -
SCPI: conform
Mode: R, A
HCOPy:TREPort:APPend
This command adds a new test report to an existing document in accordance with the test report
configuration settings. This report document is initially stored internally until it is printed using the
HCOPy:IMMediate command or exported to a portable file format.
Example: ":HCOP:TREP:APP"
Characteristics: *RST value: -
SCPI: device-specific
Mode: R, A
This command is an event, so it has neither an *RST value nor a query function.
HCOPy:TREPort:NEW
This command generates a new test report in a new document in accordance with the test report
configuration settings. An existing report document is deleted. This report document is initially stored
internally until it is printed using the HCOPy:IMMediate command or exported to a portable file format.
Example: ":HCOP:TREP:NEW"
Characteristics: *RST value: -
SCPI: device-specific
Mode: R, A
This command is an event, so it has neither an *RST value nor a query function.
The command is only available provided that the output device "printer" (HCOP:
DEST 'SYST:COMM:PRIN') has been selected.
To Next Page
Loading...
