R&S ESU Series - Page 722

Operating Manual 1302.6163.12 - 03 6.283
R&S ESU Remote Control – Description of Commands
GPIB Commands of HP Models 856xE, 8566A/B, 8568A/B and 8594E
6.23.4.3 Commands for Harmonic Distortion
Command Supported subset Function Corresponding
HP-Models
Status
SP_HARM Executes harmonis distortion
measurement
HP 856xE available in V4.1x and
above
SP_H_MAX Maximum harmonic to be
measured, range is from 2 to 10
HP 856xE available in V4.1x and
above
SP_H_FFLAG Displays or hides harmonics HP 856xE available in V4.1x and
above
SP_HPWMIN Minimum resolution bandwidth HP 856xE available in V4.1x and
above
SP_H_LVL
[1..10]
Array of amplitudes for each
harmonic in dBc relative to the
fundamental. SP_H_LVL[1] = 0
(the level of the fundamental in
dBc). The index is the number of
the harmonic
HP 856xE available in V4.1x and
above
SP_THD Total harmonic distortion in
percent
HP 856xE available in V4.1x and
above
SP_H_NS[1..10] Array of flags corresponding to
each measurement in the
SP_H_LVL array. A value of 0
denotes a good measurement
HP 856xE available in V4.1x and
above
SP_H_FRQ Frequency of the fundamental in
Hz
HP 856xE available in V4.1x and
above
SP_H_AMP Amplitude of the fundamental in
dBm
HP 856xE available in V4.1x and
above