R&S ESU Series - Page 752

Operating Manual 1302.6163.12 - 03 6.313
R&S ESU Remote Control – Description of Commands
Differences in GPIB Behavior between the FSP and the FSE Families of Instruments
R&S
ESU
FSE INPut<1|2>:ATTenuation:AUTO:MODE NORMal | LNOise |
LDIStorsion
not available for models
3 and 7;
not available for
R&S ESU
FSET/
ESIB
INPut<1|2>:ATTenuation:PROTection ON | OFF not available for
R&S ESU
R&S
ESU
INPut<1|2>:ATTenuation:PROTection:PRESet new function for
R&S ESU
FSET INPut<1|2>:ATTenuation:STEPsize 1dB | 10dB not available for
R&S ESU
FSET INPut<1|2>:BIMPedance 150OHM | 600OHM |
10kOHM
not available for
R&S ESU
FSET INPut<1|2>:COUPling AC | DC only available for
R&S ESU models 3, 8,
26
INPut<1|2>:EATT 0 to 30dB new function for
R&S ESU
INPut<1|2>:EATT:AUTO ON | OFF new function for
R&S ESU
INPut<1|2>:EATT:STATe ON | OFF new function for
R&S ESU
FSET INPut<1|2>:GAIN 0 to 30dB not available for
R&S ESU
FSET/
ESIB
INPut<1|2>:GAIN:AUTO ON | OFF not available for
R&S ESU
R&S
ESU
FSE INPut<1|2>:GAIN:STATe ON | OFF
R&S
ESU
FSE INPut<1|2>:IMPedance 50 | 75
FSE INPut<1|2>:IMPedance:CORRection RAM | RAZ not available for
R&S ESU
FSET INPut<1|2>:LISN:PEARth GROunded | FLOating not available for
R&S ESU
FSET INPut<1|2>:LISN:PHASe L1 | L2 | L3 | N not available for
R&S ESU
FSET INPut<1|2>:LISN[:TYPE] TWOphase |
FOURphase | OFF
not available for
R&S ESU
R&S
ESU
FSE INPut<1|2>:MIXer <numeric_value> not available for
R&S ESU
FSET INPut<1|2>:PRESelection:COUPling ON | OFF not available for
R&S ESU
FSET INPut<1|2>:PRESelection:COUPling:HIGH:
FREQuency
5MHz to 500MHz not available for
R&S ESU
FSET INPut<1|2>:PRESelection:COUPling:HIGH:SET 'name of preselector set
for high RBW'
not available for
R&S ESU
Devices Command (Sheet 25 of 47) Parameter Notes