R&S ESU Series - Page 753

R&S ESU Remote Control – Description of Commands
Differences in GPIB Behavior between the FSP and the FSE Families of Instruments
6.314 Operating Manual 1302.6163.12 - 03
FSET INPut<1|2>:PRESelection:COUPling:LOW:
FREQuency
10Hz to 5MHz not available for
R&S ESU
FSET INPut<1|2>:PRESelection:COUPling:LOW:SET 'name of preselector set
for low RBW'
not available for
R&S ESU
FSET INPut<1|2>:PRESelection:COUPling:MID:SET 'name of preselector set
for medium RBW'
not available for
R&S ESU
FSET INPut<1|2>:PRESelection:FILTer:HPASS[:
FREQuency]
100Hz to 5MHz not available for
R&S ESU
FSET INPut<1|2>:PRESelection:FILTer:LPASS[:
FREQuency]
20KHz to 40MHz not available for
R&S ESU
FSET INPut<1|2>:PRESelection:FILTer[:STATe] ON | OFF not available for
R&S ESU
FSET INPut<1|2>:PRESelection:SET NARRow | NORMal |
WIDE
not available for
R&S ESU
FSET INPut<1|2>:PRESelection:USET[:SELect] 'name of user defined
preselector set'
not available for
R&S ESU
FSET INPut<1|2>:PRESelection[:STATe] ON | OFF not available for
R&S ESU
FSET INPut<1|2>:TYPE RF | BALanced not available for
R&S ESU
ESIB INPut<1|2>:TYPE INPUT1 | INPUT2 not available for
R&S ESU
FSE INPut<1|2>:UPORt<1|2>:STATe ON | OFF not available for
R&S ESU
FSE INPut<1|2>:UPORt<1|2>[:VALue]? not available for
R&S ESU
ESIB INPut2:COUPling AC | DC not available for
R&S ESU
INSTrument:COUPle NONE | RLEVel | CF_B |
CF_A
available coupling
modes between Screen
A and Screen B have
been changed between
FSE and R&S ESU
FSE INSTrument:COUPle NONE | MODE | X | Y |
CONTrol | XY |
XCONtrol | YCONtrol |
ALL
Available coupling
modes between screen
A and screen B have
been changed between
FSE and R&S ESU
INSTrument<1|2>:NSELect 1 currently only parameter
value 1 available
ESIB INSTrument<1|2>:NSELect 1 to 3 | 6 4 parameter values are
available
FSE/
FSIQ
INSTrument<1|2>:NSELect 1 to 5 5 parameter values are
available
FSET INSTrument<1|2>:NSELect 1 | 2 | 6 3 parameter values are
available
INSTrument<1|2>[:SELect] SANalyzer Currently only
SANalyzer available
Devices Command (Sheet 26 of 47) Parameter Notes