R&S ESU Series - Page 837

R&S ESU Error Messages
SCPI-Specific Error Messages
9.6 Operating Manual 1302.6163.12 - 03
-214 Trigger deadlock
The trigger source for the initiation of measurement is set to GET and subsequent
measurement is received. The measurement cannot be started until a GET is
received, but the GET would cause an interrupted-error)
-215 Arm deadlock
The trigger source for the initiation of measurement is set to GET and subsequent
measurement is received. The measurement cannot be started until a GET is
received, but the GET would cause an interrupted-error.
-220 Parameter error
The command contains a faulty or invalid parameter.
-221 Settings conflict
There is a conflict between setting of parameter value and instrument state.
-222 Data out of range
The parameter value lies out of the allowed range of the instrument.
-223 Too much data
The command contains too many data.
Example: The instrument does not have sufficient storage space.
-224 Illegal parameter value
The parameter value is invalid.
Example: The text parameter is invalid, TRIGger:SWEep:SOURce TASTe
-230 Data corrupt or stale
The data are incomplete or invalid.
Example: The instrument has aborted a measurement.
-231 Data questionable
The measurement accuracy is suspect.
-240 Hardware error
The command cannot be executed due to problems with the instrument hardware.
-241 Hardware missing
Hardware is missing.
Example: An option is not fitted.
-250 Mass storage error
A mass storage error occurred.
-251 Missing mass storage
The mass storage is missing.
Example: An option is not installed.
-252 Missing media
The media is missing.
Example: There is no memory stick connected.
Error code Error text in the case of queue poll
Error explanation