R&S TSMA6 - NESTOR and NESTOR Probe Mode

Configuring the R&S TSMA6
R&S
®
TSMA6
36Getting Started 4900.8040.02 ─ 07
Figure 6-5: Scanner ready
For more details about the QualiPoc configuration and usage, refer to the user
documentation for QualiPoc
®
.
6.3.4 NESTOR and NESTOR Probe Mode
The NESTOR mode is only displayed if the NESTOR setup has been exe-
cuted (see R&S
TSMA6 user manual).
General
●
NESTOR Mode
The NESTOR UI engine and the NESTOR measurement engine are hosted
on the R&S TSMA6.
●
NESTOR Probe Mode
The R&S TSMA6 hosts only the NESTOR measurement engine. The NES-
TOR UI engine is hosted on a remote PC connected via LAN/WLAN with the
R&S TSMA6.
Prerequisites
●
For NESTOR and NESTOR Probe mode:
– NESTOR option licenses either installed on the internal SD card or con-
nected as an external USB dongle
●
For NESTOR mode only:
– NESTOR workspace file imported (see "Import NESTOR workspace file"
on page 41
●
For NESTOR Probe mode only:
Measurement Modes