Configuring the R&S TSMA6
R&S
®
TSMA6
39Getting Started 4900.8040.02 ─ 07
6.3.5 ROMES Mode
The ROMES mode is only displayed if the ROMES setup has been execu-
ted (see R&S
TSMA6 user manual).
General
In the "ROMES" mode, the ROMES software is hosted on the R&S TSMA6 and
the selection of a valid workspace file is required.
In this mode, ROMES software starts with the configured workspace file.
Prerequisites
●
A ROMES license dongle must be connected to a USB port of the
R&S TSMA6.
●
To control a ROMES measurement via IP from an external host PC, the
ROMES option ROMES4RCO is required.
●
After the installation, R&S ROMES must be started first time manually via the
program icon. Then the required directory structure is created on the
R&S TSMA6 and the workspace file can be selected via web-GUI (see Chap-
ter 6.4, "Import of Workspace Files (NESTOR, ROMES)", on page 41).
To use the R&S TSMA6 with R&S ROMES, the following steps must be per-
formed.
1. In the web GUI, set the "Mode of Operation" to "ROMES" and press "Submit".
2. Configure the following settings.
● Workspace File
Measurement Modes
To Next Page
Loading...
