Data management
R&S
®
ZNL/ZNLE
101User Manual 1178.5966.02 ─ 20
File Explorer
Opens the Microsoft Windows File Explorer.
Remote command:
not supported
File Type
Determines whether the global instrument settings with all "Channel"s are stored or
recalled, or the current "Channel" settings only.
Items:
Defines which data and settings are stored or are recalled. Depending on the "File
Type" , either channel setups only, or global settings are available. Which items are
available also depends on the installed options (see also Chapter 6.2.2.1, "Stored data
types", on page 98).
Save File
Saves the settings file with the defined filename.
Remote command:
MMEMory:STORe<1|2>:STATe on page 587
MMEMory:STORe<1|2>:STATe:NEXT on page 587
Recall in New Channel / Recall in Current Channel
Restores the instrument settings as saved in the selected settings file. If the settings
file contains settings for a specific "Channel" only, select "Recall in New Channel" to
activate a new channel setup with the stored settings. Select "Recall in Current Chan-
nel" to replace the current "Channel" settings.
Note: After you use the "Recall" function, the history of previous actions is deleted, i.e.
any actions performed previously cannot be undone or redone using the [UNDO/
REDO] keys.
Remote command:
MMEMory:LOAD:STATe on page 585
6.2.2.4 Startup recall settings
Access: "Open" icon in the toolbar > "Startup Recall"
Storing and recalling instrument settings and measurement data
To Next Page
Loading...
