Command reference
R&S
®
ZNL/ZNLE
621User Manual 1178.5966.02 ─ 20
SYSTem:PRESet:COMPatible <OpMode>
This command defines the operating mode that is activated when you switch on the
R&S ZNL/ZNLE or press the [PRESET] key.
Parameters:
<OpMode> VNA
Defines the Vector Network Analysis mode as the presetting
(default).
SANalyzer
Defines Signal and Spectrum Analyzer operating mode as the
presetting.
Manual operation: See "Preset Mode" on page 133
11.3.4.7 Using service functions
DIAGnostic:SERVice:SFUNction......................................................................................621
DIAGnostic:SERVice:SFUNction:LASTresult?...................................................................622
DIAGnostic:SERVice:SFUNction:RESults:DELete............................................................. 622
DIAGnostic:SERVice:SFUNction:RESults:SAVE................................................................622
DIAGnostic:SERVice:SINFo?.......................................................................................... 622
SYSTem:PASSword[:CENable]........................................................................................623
SYSTem:PASSword:RESet............................................................................................. 623
DIAGnostic:SERVice:SFUNction <ServiceFunction>
DIAGnostic:SERVice:SFUNction? <ServiceFunction>
This command starts a service function.
The service functions are available after you have entered the level 1 or level 2 system
password.
Parameters for setting and query:
<ServiceFunction> String containing the ID of the service function.
The ID of the service function is made up out of five numbers,
separated by a point.
• function group number
• board number
• function number
• parameter 1 (see the Service Manual)
• parameter 2 (see the Service Manual)
Return values:
<Result>
Example:
DIAG:SERV:SFUN 'Function1'
DIAG:SERV:SFUN? 'Function2'
Manual operation: See "Service Function" on page 138
Common instrument commands
To Next Page
Loading...
