R&S ZNLE Series - Hcopy:page:margin:top; Hcopy:page:margin:unit; Hcopy:page:orientation; Hcopy:page:window:channel:state

Command reference
R&S
®
ZNL/ZNLE
595User Manual 1178.5966.02 ─ 20
Manual operation: See "Margins" on page 114
HCOPy:PAGE:MARGin:TOP <Top>
This command defines the margin at the top of the printout page on which no elements
are printed. The margins are defined according to HCOPy:PAGE:MARGin:UNIT
on page 595.
Parameters:
<Top> *RST: 4.23 mm
Example:
HCOP:PAGE:MARG2:TOP 2
Manual operation: See "Margins" on page 114
HCOPy:PAGE:MARGin:UNIT <Unit>
This command defines the unit in which the margins for the printout page are config-
ured.
Parameters:
<Unit> MM | IN
MM
millimeters
IN
inches
*RST: MM
Example:
HCOP:PAGE:MARG2:BOTT 2
Manual operation: See "Margins" on page 114
HCOPy:PAGE:ORIentation <Orientation>
The command selects the page orientation of the printout.
The command is only available if the output device is a printer or a PDF file.
Parameters:
<Orientation> LANDscape | PORTrait
*RST: PORTrait
Example:
HCOP:DEV:LANG1 PDF
HCOP:PAGE:ORI2 LAND
Manual operation: See "Orientation" on page 113
HCOPy:PAGE:WINDow:CHANnel:STATe <Channel>, <State>
This command selects all windows of the specified channel setup to be included in the
printout for HCOPy:CONTent on page 590.
Common instrument commands