R&S ZNLE Series - Config Tab

VNA GUI reference
R&S
®
ZNL/ZNLE
561User Manual 1178.5966.02 ─ 20
10.14.9 Config tab
The "Config" tab provides means to configure the overall "Offset Embed" calculation.
Offset > Calculate after De-/Embed.
Changes the position of the "Offset" calculation in the "Offset Embed" calculation
chain.
If unchecked (default), the offset is calculated before de-/embedding. If checked, it is
calculated after de-/embedding.
Top
= Default offset calculation
Bottom = Offset calculation after de-/embedding (GUI mockup)
Remote command:
[SENSe:]CORRection:EDELay:VNETwork
Offset Embed softtool